L2Tpclient - D-Link NetDefend DFL-210 Cli Reference Manual

3.22.5. L2TPClient

OriginatorIP
IKEMode
DHGroup
PFS
PFSDHGroup
SetupSAPer
DeadPeerDetection
NATTraversal
KeepAlive
KeepAliveSourceIP
KeepAliveDestinationIP
Metric
AutoInterfaceNetworkRoute
MTU
Comments
3.22.5. L2TPClient
Description
A PPTP/L2TP client interface is a PPP (Point-to-Point Protocol) tunnel over an existing IP network.
Its IP address and DNS servers are dynamically assigned.
Properties
Name
IP
Note
If no Index is specified when creating an instance of this type, the object will be
placed last in the list and the Index will be equal to the length of the list.
Manually specified originator IP address to use as source IP
in e.g. NAT.
Specifies which IKE mode to use: main or aggressive.
(Default: Main)
Specifies the Diffie-Hellman group to use when doing key ex-
changes in IKE. (Default: 2)
Specifies whether PFS should be used or not. (Default: None)
Specifies which Diffie-Hellman group to use with PFS.
(Default: 2)
Setup security association per network, host or port. (Default:
Net)
Enable Dead Peer Detection. (Default: Yes)
Enable or disable NAT traversal. (Default: OnIfNeeded)
Disabled, Auto or Manual. (Default: Disabled)
Source IP address used when sending keep-alive ICMP pings.
Destination IP address used when sending keep-alive ICMP
pings.
Specifies the metric for the auto-created route. (Default: 90)
Automatically add a route for this interface using the given
remote network. (Default: Yes)
Specifies the size (in bytes) of the largest packet that can be
passed onward. (Default: 1500)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
The host name to store the assigned IP address in, if this net-
work object exists and have a value other then 0.0.0.0 the
PPTP/L2TP client will try to get that one from the PPTP/
L2TP server as preferred IP. (Optional)
91
Chapter 3. Configuration Reference