Clearing The Enforce Host Tag Search For Cfs Setting; Setting Up Security Services For Sonicwall Cdp - SonicWALL CDP 6.0 Administrator's Manual

•

Clearing the Enforce Host Tag Search for CFS Setting

To clear the Enforce Host Tag Search for CFS setting, perform the following steps:
In your browser, navigate to the unlinked Diag page for the SonicWALL network security
Step 1
appliance, available at:
https://<firewall IP address>/diag.html
In the left pane, click on the Internal Settings button.
Step 2
Under Security Services Settings in the right pane, clear the Enforce Host Tag Search for CFS
Step 3
checkbox.
Click Accept at the top of the page.
Step 4
Click the Close button to return to the SonicOS management interface.
Step 5

Setting up Security Services for SonicWALL CDP

This section describes the steps needed when adding a SonicWALL CDP appliance to your
network when you are running SonicOS Security Services. To prevent the Security Services
from blocking access to your SonicWALL CDP appliance, you must configure SonicOS Security
Services with exclusions for the IP address of the appliance.
To configure SonicOS Security Services with exclusions for the SonicWALL CDP appliance,
perform the following steps:
Navigate to the Security Services > Content Filter page.
Step 1
Under CFS Exclusion List, select the Enable CFS Exclusion List checkbox.
Step 2
Click the Add button and add the SonicWALL CDP IP address to the list.
Step 3
Click OK in the Add dialog box, then click Apply on the Content Filter page.
Step 4
Navigate to the Security Services > Client AV Enforcement page.
Step 5
Under Administration, click Configure.
Step 6
In the AV Config View window, under Client Anti-Virus Enforcement, select the Exclude
Step 7
specified address ranges from Client Anti-Virus enforcement radio button.
Click the Add button and add the SonicWALL CDP IP address to the list.
Step 8
Click OK in the Add dialog box and Config View window, then click Apply on the Client AV
Step 9
Enforcement page.
Navigate to the Security Services > Gateway Anti-Virus page.
Step 10
Under Gateway AV Settings, select the Enable HTTP Byte-Range requests with Gateway
Step 11
AV checkbox.
Under Gateway Anti-Virus Global Settings, click the Configure Gateway AV Settings
Step 12
button.
In the Gateway AV Config View window, under Gateway AV Exclusion List, select the
Step 13
Enable Gateway AV Exclusion List checkbox.
Click the Add button and add the SonicWALL CDP IP address to the list.
Step 14
"Setting up Security Services for SonicWALL CDP" on page 233
Configuring SonicOS Security Services for SonicWALL CDP
SonicWALL CDP 6.0 Administrator's Guide 233