Maintenance - Worx WG155 User Manual

until it is long enough to reach the line cutter.
If the line extends past the line cutter, too
much line has been fed out.
If too much line is fed out, remove the spool
cap and turn spool counter-clockwise until the
line is at the desired length.
To REmovE THE CaP (See Fig. k2)
Press and hold in the two latches (12).
Pull spool cap cover away from the spool
holder
When refitting the spool cap.
Keep all areas of the cap and spool holder clean.
Replace the cap, pressing firmly down towards
the spool holder to ensure cap is fully located
into position.
Check that the cap is correctly fitted by trying
to remove it without depressing the two
latches.
To REPlaCE THE TRimmER liNE.
Turn off the trimmer and remove the battery.
Remove spool cap cover.
For your convenience it is recommended you
buy replacement spools with the trimmer line
12 12
preinstalled.
To FiT SPool aNd liNE aSSEmBly(See
Fig. k3)
Remove old spool from spool holder. Clear any
broken line or cutting debris from the spool
area. Pull the line from the new replacement
spool through the eyelet of the spool holder.
Place new spool into holder with cut out areas
of the spool facing inward or down. When
installed into the spool holder, the smooth side
of the spool should be visible.
Release line from cleat on the spool.
Refit the cap.
To FiT NyloN liNE oNly:
waRNiNG! Take approximately 10ft
(3m) of line. Insert 5/8"(15mm )of line
into the spool holes and wind line in the
direction of the arrows on the top of the spool.
Your Trimmer is designed to use only line
with a maximum diameter of 0.065" /
1.65mm.
imPoRTaNT: Leave approximately 4"
(100mm) of line unwound and place into cleat.
2 in 1 Grass Trimmer/Edger
Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will
impair the efficiency of the automatic line feed.
Then fit spool as described in "To fit spool
and line assembly".
sTorING YoUr GrAss
TrIMMEr
a) aSSEmBly oF THE wall mouNT
BRaCkET (See Fig. l)
Tighten all the screws securely. Carefully check
the bracket after mounting to make sure that
no movement can occur during use.
waRNiNG: Always make sure your
wall-mount bracket is securely mounted
to the wall. Failure to do so could result in an
accident, resulting in possible serious personal
injury.
b) SToRiNG youR GRaSS TRimmER
(See Fig. m)
Adjust the auxiliary handle position close to
the main handle and lower it into the bracket,
now the grass trimmer can be stored into the
wall mount bracket as illustrated.

MAINTENANCE

After use, disconnect the battery from the tool
and check for damage.
Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry
room temperature location. Keep the motor
ventilation slots clean. Keep all working
controls free of dust.
EN