Connecting Your Ltm-4X4Hdsdi 4X4 Hd-Sdi / Sdi Router - Laird LTM-4x4HDSDI User Manual

Connecting Your LTM-4x4HDSDI 4x4 HD-SDI / SDI Router

6 Connecting Your LTM-4x4HDSDI 4x4 HD-SDI / SDI Router
You can use your LTM-4x4HDSDI to switch one of the four standard
definition / high definition SDI inputs to any or all of the four standard
definition / high definition SDI outputs, as the illustration in Figure 2 shows.
To connect the LTM-4x4HDSDI 4x4 HD-SDI / SDI Router, do the
1
following :
1. Connect up to four SDI sources to the SDI INPUT BNC connectors (for
example, an HD/SD SDI camera to input 1 and an HD video player to input 4).
2. Connect the SDI OUTPUT BNC connectors to up to
(for example, output 1 to a Preview monitor, and output 4 to an HD SDI
mixer).
3. Set the dipswitches (see section 6.1).
4. As an option
A Genlock source to the GENLOCK BNC connector
The LOOP BNC connector to the GENLOCK connector of the next
unit in the line, and release the TERM button for looping
5. Connect a PC and/or controller (if required), to the:
RS-232 port (see section 6.2), and/or
RS-485 port (see section 6.3), and/or
ETHERNET connector (see section 6.4)
6. As an option
7. Connect the power cord
The example in Figure 2 illustrates how to connect your LTM-4x4HDSDI:
1 Switch OFF the power on each device before connecting it to your LTM-4x4HDSDI. After connecting your
LTM-4x4HDSDI, switch on its power and then switch on the power on each device
2 When only one output is required, connect that output, and leave the other outputs unconnected
3 Not illustrated in Figure 2
4 Pushed in terminates the input. Release when the input extends to another unit
5 We recommend that you use only the power cord that is supplied with this machine
6
3
, connect:
3
, connect a remote dry contact switch (refer to section 6.5)
5
.
2
four SDI acceptors
4