Controlling Via Ethernet; Connecting The Ethernet Port Directly To A Pc (Crossover Cable); Figure 5: Rj-45 Pinout; Table 4: Crossover Cable Rj-45 Pinout - Laird LTM-4x4HDSDI User Manual

Connecting Your LTM-4x4HDSDI 4x4 HD-SDI / SDI Router

6.4 Controlling via ETHERNET

You can connect the LTM-4x4HDSDI via the Ethernet, using a crossover
cable (see section 6.4.1) for direct connection to the PC or a straight through
cable (see section 6.4.2) for connection via a network hub or network router
6.4.1 Connecting the ETHERNET Port directly to a PC (Crossover
Cable)
You can connect the Ethernet port of the LTM-4x4HDSDI to the Ethernet
port on your PC, via a standard crossover cable with RJ-45 connectors, as
Table 4 and Figure 5 define.

Table 4: Crossover Cable RJ-45 PINOUT

EIA /TIA 568A
Side 1
PIN Wire Color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Pair 1 4 and 5
Pair 2 1 and 2
Pair 3 3 and 6
Pair 4 7 and 8
This type of connection is recommended for identification of the factory default
IP Address of the LTM-4x4HDSDI during the initial configuration
After connecting the Ethernet port, configure your PC as follows:
1. Right-click the My Network Places icon on your desktop.
Select Properties.
2.
1 After connecting the Ethernet port, you have to install and configure your Ethernet Port and also install the COM Port
Redirector.
10
EIA /TIA 568B
Side 2
PIN Wire Color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
8 Brown
Pair 1 4 and 5
Pair 2 3 and 6
Pair 3 1 and 2
Pair 4 7 and 8

Figure 5: RJ-45 PINOUT

1
.