Toggling Between The At Once And Confirm Modes; Confirming A Switching Action - Laird LTM-4x4HDSDI User Manual

the "TAKE" button, to simultaneously activate the multiple switches
Every action requires user confirmation, protecting against erroneous
switching
Execution is delayed until the user confirms the action
Note that after ten seconds the LTM-4x4HDSDI will go to standby mode and
the buttons and the 7-segment display will illuminate less brightly
7.2.1

Toggling between the AT ONCE and CONFIRM Modes

To toggle between the AT ONCE and CONFIRM modes, do the following:
1. Press the dim TAKE button to toggle from the AT ONCE mode (in
which the TAKE button is dim) to the CONFIRM mode (in which the TAKE
button illuminates).
Actions now require user confirmation and the TAKE button illuminates.
2. Press the illuminated TAKE button to toggle from the CONFIRM mode
back to the AT ONCE mode.
Actions no longer require user confirmation and the TAKE button no longer
illuminates.
7.2.2

Confirming a Switching Action

To confirm a switching action (in CONFIRM mode- where the TAKE button
is illuminated), do the following:
1. Press an OUT-IN combination.
The 7-segment Display blinks
2. Press the TAKE button to confirm the action.
The 7-segment Display no longer blinks. The TAKE button illuminates.
To confirm several actions (in CONFIRM mode), do the following:
1. Press each OUT-IN combination in sequence.
The 7-segment Display blinks.
2. Press the TAKE button to confirm all the actions.
The 7-segment Display no longer blinks. The TAKE button illuminates.
1 The timeout lasts for 10 seconds
14
Operating the LTM-4x4HDSDI
1
.