Table 1: Front Panel Ltm-4X4Hdsdi 4X4 Hd-Sdi / Sdi Router; Table 2: Rear Panel Ltm-4X4Hdsdi 4X4 Hd-Sdi / Sdi Router - Laird LTM-4x4HDSDI User Manual

Table 1: Front Panel LTM-4x4HDSDI 4x4 HD-SDI / SDI Router

# Feature
1 IR Receiver
2 POWER Switch
3 INPUT SELECTOR Buttons
4 OUTPUT SELECTOR
Buttons
5 TAKE Button
6 ALL Button
7 OFF Button
8 LOCK Button
9 RCL (RECALL) Button
10 STO (STORE) Button
11 7-segment Display

Table 2: Rear Panel LTM-4x4HDSDI 4x4 HD-SDI / SDI Router

# Feature
12 GENLOCK BNC Connector
13 TERM Button
14 LOOP BNC Connector
15 INPUT BNC Connectors
16 OUTPUT BNC Connectors
17 REMOTE Terminal Block
Connector
18 RS-232 DB 9F Port
19 RS-485 Detachable
Terminal Block Port
20 SETUP Dipswitches
21 ETHERNET Connector
22 Power Connector with Fuse
1 When in Confirm mode, the TAKE button illuminates
2 For example, press ALL and then Input button # 2 to connect input # 2 to all the outputs
3 Only view, nothing is implemented at this stage
4 For example, press STO and then the Output button # 3 to store in Setup # 3
5 Push in to terminate the input. Release when the input extends to another unit
6 Via a null-modem connection
7 The ground connection is sometimes connected to the shield of the RS-485 cable. In most applications, the ground is not
connected
4
Your LTM-4x4HDSDI 4x4 HD-SDI / SDI Router
Function
The red LED is illuminated when receiving signals from the Infra-red
remote control transmitter
Illuminated switch for turning the unit ON or OFF
Select the input to switch to the output
Select the output to which the input is switched
Pressing TAKE toggles the mode between the CONFIRM mode
the AT ONCE mode (user confirmation per action is unnecessary)
Pressing ALL followed by an INPUT button, connects that input to all
2
outputs
An OFF-OUT combination disconnects that output from the inputs; an
OFF-ALL combination disconnects all the outputs
Disengages the front panel buttons
Pressing the RCL button and the corresponding INPUT / OUTPUT
key recalls a setup from the non-volatile memory. The stored status
blinks. Pressing a different INPUT / OUTPUT button lets you view
another setup. After making your choice, pressing the RCL button
again implements the new status
Pressing STO followed by an INPUT / OUTPUT button stores the
current setting
Displays the selected input switched to the output (marked above
each input)
Function
Connect to the Genlock source
Press to terminate the Genlock source (75 ) or release for looping
Connect to the GENLOCK connector of the next unit in the line
Connect to the serial digital video sources
Connect to the serial digital video acceptors
Connect to dry contact switches
Connects to the PC or the Remote Controller
Pin G is for the Ground connection
Dipswitches for setup of the unit
Connects to the PC or other Serial Controller through computer networking
AC connector enabling power supply to the unit
4
7
; pins B (-) and A (+) are for RS-485
1
and
3
5
6