Optional Hearth Trim Installation - Regency L390E Owner's Manual

Hearth Trim is an option that can be used to fi nish off the installation when the bottom of the fi replace is higher than the hearth or to raise the fi replace.
1) For units L390E/HZI390E/L540E/HZI540E–remove 4 screws in
locations shown below to remove outer faceplate.
Diagram 1–Screw Locations
1a) For units L390PB/HZI390PB/U31/U32/E21/E33–remove outer
faceplate by lifting up and out from backing plate.
Diagram 2–Lift off Front Faceplate
**If no holes are present on the backing plate, proceed to the Step 3.
2) If screw holes are present on backing plate, secure the hearth trim
to backing place with 2 screws on each side.
Hearth Trim
Diagram 3–Hearth Trim Secured to Backing Plate
L390E-2 / HZI390E-2 Direct Vent Gas Insert
OPTIONAL HEARTH TRIM
INSTALLATION
** If no screw holes are present.
3) Remove backing plate by removing 4 screws–lay down fl at.
Diagram 4–Backing Plate Removal Units L390E/HZI390E/L540E/
Diagram 5–Backing Plate Removal Units U31/U32/E21/E33
4) Secure hearth trim to backing plate with a clip on each side as
shown in Diagram 6. Ensure the hearth trim is evenly space on
either side of the backing plate.
Clip
5) Reinstall backing plate.
6) Reinstall outer faceplate.
INSTALLATION
HZI540E
Diagram 6–Hearth Trim Clip
Hearth Trim
37