Miele Built-in coffee machine Operating And Installation Instructions page 65

Message
Fault 73
or
"Check the brew
unit"
Possible cause and remedy
^ The brew unit cannot be positioned correctly, or it is dirty
and the coffee cannot be processed.
^ Check whether you can remove the brew unit (see
"Cleaning and care - Brew unit").
^ Clean the brew unit if it can be removed (see "Cleaning and
care – Brew unit").
Push the coffee ejector of the brew unit into the correct
position (see diagram).
^ Push the waste container and the water container back in
the machine. Do not insert the brew unit. Close the door
and switch the machine on with the On/Off K sensor.
The brew unit motor will be initialised.
^ When "Insert the brew unit" appears in the display, open
the door and put all the parts back in the machine.
If the brew unit cannot be removed:
^ Switch the machine off with the On/Off K sensor. Wait for
approx. 2 minutes before switching it back on again.
Problem solving guide
65