Replacing The Ethernet Card - Intermec CK30 Service Manual

Chapter 2 — Replacing Parts

Replacing the Ethernet Card

12
To replace the Ethernet card, you may need the following tools and parts:
• T10 Torx screwdriver
• Small Phillips screwdriver
• Ethernet card assembly (P/N 073867-001)
• Ethernet cable assembly (P/N 073096-001)
• 2-56 x 3/16 stainless steel screw (P/N 801-210-000)
• 2-28 x .250 Plastite flathead screw (P/N 800-193-000)
To replace the Ethernet card
1 Open the CK30. For help, see "Opening the CK30" on page 9.
2 Disconnect the Ethernet cable from J12 on the main PCB.
3 Remove the four Phillips screws (two self-tapping flathead and two
machine) from the mini PCI shield assembly and lift the shield off of
the Ethernet card assembly.
4 Open the retainer clips and pull the Ethernet card assembly away from
the connector.
5 Insert the new Ethernet card assembly into the connector until the two
retainer clips lock in place.
Ethernet
cable
J12
Ethernet
card assembly
Screw
(2 places)
Screw
(2 places)
Mini PCI
shield
assembly
Retainer
clips
CK30 Handheld Computer Service Manual