Quick Bypass By Zone/Group; Auto Unbypass; Manual Unbypass - FBII XL-2T Installation And Setup Manual

Quick Bypass By Zone/Group

Quick Bypassing is a programmable option (question 08, location 3) and allows the user to
bypass zones and points without using a user code.
If QUICK BYPASS is enabled (question 08, location 3) and ZONE BYPASS is enabled
(question 17-23, location 3), then:
TO BYPASS by ZONE: Press the BYPASS key followed by a single digit number (1-7),
representing the respective zone to be bypassed.
EXAMPLE: Bypass Zone 6 = BYPASS 6
If QUICK BYPASS is enabled (question 08, location 3), ZONE BYPASS is enabled (question
17-23, location 3) and BYPASS BY GROUP is enabled (question 09, location 1), then:
TO BYPASS by GROUP: Press the BYPASS key followed by the # key, representing the
respective group of zones to be bypassed.
EXAMPLE: BYPASS #
NOTE: Bypassing a GROUP will only remove the individual zones enabled for that group.
After a successful bypass, the keypad sounder will emit the acknowledge beep and the
respective zone LED will BLINK SLOWLY or, on LCD keypads, display:
In addition, note the following rules for bypass:
• FIRE zones cannot be bypassed
• 24 hour zones can be bypassed, however they CANNOT be unbypassed if they are
violated.
• Zones can only be bypassed while the system is disarmed, at which time visual
indication will be displayed.
Bypass signals will be transmitted to the Central Station(CS) UPON ARMING if a bypass
code has been programmed.
ZONES WHICH ARE BYPASSED ARE NOT PROTECTED WHEN THE SYSTEM IS ARMED.

Auto Unbypass

All burglary zones which are bypassed are automatically unbypassed upon system disarm.
24-hour zones which have been bypassed will be unbypassed only if they are not validated.

Manual Unbypass

UNBYPASS removes an existing bypass from a currently bypassed zone or group. The
procedure is the same as bypass.
KEYPAD TAMPER/LOCKOUT: Upon entry of 21 keystrokes in succession without entry of a valid
command, the system will initiate a keypad tamper/Lockout condition. This will be a silent alarm.
In addition, a code can be programmed for transmission to the Central Station (see question 34,
locations 3 & 4).
BYPASS
ZONE 1, 2
Section 5 - System Operations
5–3