Table of Contents
Advertisement
Glossary of Terms
MAXIMUM SPEED (MS): Highest speed achieved since the last reset.
NORMAL MODE: Vector's standard mode.
ODOMETER (ODO): The total accumulated distance Vector has
traveled. The odometer is permanent and cannot be reset.
RALLY MODE (ADST): Rally and enduro racing requires the rider
to be able to adjust the trip distance meter (DST) quickly and easily.
During rally mode, distance adjustments are as easy as pressing a
button on the remote switch. Rally mode requires the remote switch.
REMOTE SWITCH: Mounts to handlebar next to grips. The remote's
buttons act as duplicates of the buttons on the main computer. The
remote is required to access lap timer and rally modes.
RIDE TIME (RT): Shows how long the engine has been running since
the last reset.
SENSORS: The speed sensor works with the magnet to let Vector
collect its wheel data and a second sensor will measure the temperature.
SLEEP MODE: If Vector doesn't receive any sensory information it
will go into Sleep Mode and only display the clock.
SPEED (SPD): The current speed the vehicle is traveling.
STOP WATCH (TT): A short term, regular stop watch.
WHEEL SIZE: Very important. Used to determine speed and distance.
Refer to the Wheel Measurement section for an accurate measurement.
43
- Quick Links:
- Quick Start
- Specifications
- Reset Button
- Installation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Vector and is the answer not in the manual?
Questions and answers
how to change time
To change the time on a Trail Tech Vector:
1. Enter Data Setting Mode.
2. Cycle between 12-hour and 24-hour format by pressing the Left button. Confirm by pressing the Center button.
3. To set the time of day:
- Modify the flashing digit by pressing the Left button.
- Change to the next digit by pressing the Right button.
- Confirm each digit by pressing the Center button.
This answer is automatically generated