Table of Contents
Advertisement
The screen is hazy or crazed.
•
Did gasoline, degreasers, or other chemical cleaners come in
contact with Vector's screen? Some chemicals can damage Vector.
The backlight won't stay lit.
•
Vector needs to be connected to vehicle's 12 volt system in order
for the backlight to be continuous on. Review installation procedure.
See page 9.
Vector's internal battery is dead.
•
To replace the battery, use a coin to unscrew the round panel on
the back of Vector. Remove the old battery and install the new
one. Make sure the positive pole is facing up. Replace with
common watch battery CR2302. See page 10.
Why aren't the LED's working?
•
Vector needs to be connected to vehicle's 12 volt system in order
for the LED's to function.
•
Settings must be programmed manually. See pages 8, 22, and 35.
A wire came unplugged, and now the sensors don't work.
•
A data reset must be performed in order for Vector to re-recognize
the sensors if they become unplugged. Perform a reset by pressing
<LEFT>+<CENTER> or the reset button on the back of Vector.
REMEMBER TO PAY ATTENTION
TO THE TRAIL WHILE RIDING.
Troubleshooting
41
- Quick Links:
- Quick Start
- Specifications
- Reset Button
- Installation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Vector and is the answer not in the manual?
Questions and answers
how to change time
To change the time on a Trail Tech Vector:
1. Enter Data Setting Mode.
2. Cycle between 12-hour and 24-hour format by pressing the Left button. Confirm by pressing the Center button.
3. To set the time of day:
- Modify the flashing digit by pressing the Left button.
- Change to the next digit by pressing the Right button.
- Confirm each digit by pressing the Center button.
This answer is automatically generated