Table of Contents
Advertisement
NOTE: If you ran the red reverse osmosis drain tubing
directly to a remote drain point, disregard
steps 5 and 6
and refer to instructions
on page 10.
6. Mount the faucet body on to the faucet base, 1/4 turn.
FAUCET
ELECTRONICS
The RO system will monitor
the total product
flow of
the unit and also length of time the filters have been
installed.
The faucet base has an indicator
light that
flashes to inform you of the status of the RO membrane
and filters.
Green - RO membrane
and filters are good.
BLUE
3/8" quick connect
fitting for the blue tube
BLACK TUBE
3/8" barb fitting
for the black tube
UBE
1/4" barb fitting
for the red tube
Amber - Warning,
filters need replacing.
Filters need
replacing,
when water has been drawn,
after 6 months
time (or 650 gallons have been used).
Figure 14
Red - RO membrane
needs to be replaced.
INSTALL
BATTERY
When the coin battery is first applied
at initial start up,
the LED indicator
light will flash in a red, amber, green
sequence.
All timers and counters
are reset to zero. in
order to reset the time and gallon count feature, push the
the button
on the PWA and hold until the LED flashes
and release. The battery needs to be replaced
at the time
of filter replacement.
Use only lithium batteries
(CR 2032
or equivalent).
Improper
placement
of battery
could
damage
electronics.
Use care when inserting
the battery
to align it correctly
on PWA with the proper
polarity.
See
Figure 15.
PWA board
Battery /
Reset button
Figure 15
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
13
Advertisement
Table of Contents
