Securing The Oven In The Opening; Mounting The Oven - GE JCKS10 Installation Instructions Manual

Installation Instructions

Securing the Oven in the Opening

C
Sliding the Oven Into the
C1
Opening
a. Loop (do not tie) a 91 cm (36") string
around the conduit before the oven is slid
into place. This will keep the conduit from
falling behind the oven.
b. Lift oven into cabinet cutout using the oven
opening as a grip. Carefully push against
oven front frame. Do not push against
outside edges.
c. As you slide the oven back, pull the string
so that the conduit will lie on top of the
oven in a natural loop.
d. When you are sure the conduit is out of the
way, slide the oven 3/4 way back into the
opening. Remove the string by pulling on
one end of the loop.
C2
a. Drill through the mounting holes (top and
Pull out on
string loop
while pushing
the oven into
the cabinet
b. Secure the oven to cabinet with screws
NOTE: If the cabinet is particle board, you
must use #8 x 19 mm (3/4") particle board
screws. These may be purchased at any
hardware store.
10
Drilling the Pilot Holes and

Mounting the Oven

NOTE: Before drilling the pilot holes,
make sure the oven is pushed as far
back into the opening as it will go
and is centered.
bottom) of the side trim, for the #8 screws
provided.
Mounting
Hole
Locations
(Hole
Locations
may vary)
WARNING:
screws must be used. Failure to
do so could result in the oven
falling out of the cabinet, causing
serious injury.
provided.
The screws must
be a minimum
of 6 mm (1/4")
from the front of
the cutout.
Mounting