Securing The Oven In Opening - GE JTP85 Series Installation Instructions Manual

SECURING THE OVEN
IN OPENING
With the Conduit connected, the oven is ready to be
12
slid into the cutout opening.
a. Loop a 36" string
around the
conduit before the
oven is slid into
place. This will
keep the conduit
from falling
behind the oven.
b. Lift oven into
cabinet cutout
using the oven
opening as an
grip. Carefully
push against oven
front frame. Do
not push against
outside edges.
c. As the oven is slid
back, pull the string so that the conduit will lie behind
the oven in a natural loop.
d. When you are sure the conduit is out of the way, slide
the oven all the way back into the opening, remove the
string.
NOTE: Before drilling the pilot holes, make sure
the oven is pushed as far back into the opening as it
will go and that it is centered.
Drill four-1/8" pilot holes through the mounting
13
holes (top and bottom) of the side trim, for the four
#8 screws provided.
NOTE: Mounting screws must be used. Failure to
do so could result in the oven falling out of the
cabinet causing serious injury.
Secure the Oven to Cabinet with screws provided.
14
6
The screws must be a
minimum of 1/4" from
the front of the cutout.