GE JCKS10 Installation Instructions Manual page 4

Installation Instructions
Cutout for 27"
A
Ovens only
For JCKP30, JCKP70, JCKS10, PCK916, PCK920 models only.
Allow 2.5 cm (1")
for overlap of oven
over side edges of
cutout
5 cm x 10 cm
(2" x 4")
or equivalent
runners level
with bottom
of cutout
50.8 cm
(20")
Allow a minimum
of 50.8 cm (20") for
clearance to adjacent
corners, drawers, walls,
etc. when door is open
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. For single
ovens, the runners and braces must
support 68 kg (150 lbs.).
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
(68.6 cm)
12.7 cm
(5") Max.
from the left
or right
Cabinet
side
Width
Junction Box
68.6 cm
Location
(27")
Cutout Width
63.5 cm
(25") Min.
64.1 cm
(25 1/4") Max.
Cutout
Height
70.2 cm (27 5/8") Min.
71.4 cm (28 1/8") Max.
Recommended
Allow 2.5 cm
cutout location
(1") minimum
from floor 82.6 cm
for overlap of
(32 1/2")
oven top and
bottom of cutout
Single Built-In
Cabinet Width
Recommended
Cutout Location
from Floor
Cutout Depth
Cutout Width
55.9 cm (22") Min.
above base rail
Cutout Height
Alternate
Junction Box
Location –
access from
adjacent
NOTE: If the cabinet does not
cabinet may
be required
have a front frame and the sides
are less than 1.9 cm (3/4") thick,
shim both sides equally to
establish the cutout width.
61 cm
24"
(24")
These ovens are not approved
for stackable installation.
4
68.6 cm (27")
82.6 cm (32 1/2")
59.7 cm
(23 1/2") Min.
63.5 cm
(25") Min.
64.1 cm
(25 1/4") Max.
70.2 cm
(27 5/8") Min.
71.4 cm
(28 1/8") Max.
2" x 4" or
5 cm x 10 cm (2" x 4") or
equivalent runners level
Equivalent
with bottom of cutout
Runners
18"
45.7 cm (18")
68.6 cm (27") 27"