GE JCKS10 Installation Instructions Manual page 8

Installation Instructions
Cutout for 30"
A
Ovens only – Over a Warming Drawer
For JCTP30, JCTP70, PCT916, PCT920 models only.
Per Warming
Drawer
Requirement
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth and
height.
(76.2 cm)
1" (2.5 cm) Min. Above Toekick or
Adjust to Oven Installation Height
• When installing a Warming Drawer below
8
Single Built-In
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
a single oven, a separate 120V, 60 Hz,
properly grounded receptacle must
be installed. Refer to installation instructions
packed with the Warming Drawer for specific
installation requirements.
2" (5.1 cm) Min.
NOTE: Install the
oven only with
specific models
listed on the label
located on top of
the oven.