Fault Finding Chart; Maintenance; Environmental Information - Flymo Trimmer Original Instructions Manual

WARNING Disconnect from the mains electricity supply before attempting any
FAULT
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS
CLATTERING NOISE
LINE SNAPS CONTINU-
OUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
After you have finished using your trimmer follow
the procedure below:
1. Disconnect from the mains electricity supply.
2. Never clean your trimmer with water, cleaning
fluids, or solvents, just remove debris with a
suitable tool, a soft brush or dry cloth.
3. Using a soft brush, clean around the inside of
the safety guard, the cutting head and the
motor housing air vents. (Fig L, M).
4. Inspect the trimmer carefully, especially the
parts of the cutting head.
5. If your trimmer is damaged in any way contact
your local approved service centre.
• Never use a damaged trimmer.
6. Wind cable carefully to avoid kinking.
7. Store in a cool, dry place and out of reach of
children.
Awareness of the environment must be
•
considered when disposing of 'end-of-life'
product.
• If necessary, contact your local authority for
disposal information.
The symbol on the product or on its
packaging indicates that this product may not be
treated as household waste. Instead it shall be
handed over to the applicable collection point for

Fault Finding Chart

maintenance or adjustment.
CHECK
Is the line fed out and visible?
Is the manual line feed working?
Has the motor reached full
speed before use?
Has too much line been fed
out?
Is the line cutter missing from
the safety guard?
Are you using the trimmer
correctly
?
Is the line jamming on the
spool?
Contact Husqvarna UK Ltd. Customer Service
Telephone : 0844 844 4558

Maintenance

L
M

Environmental Information

the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly,
you will help prevent potential negative
consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product.
For more detailed information about recycling of
this product, please contact your local council
office, your household waste disposal service or
the shop where you purchased the product.
ACTION
Remove cap and spool, free
No
line and re-fit spool and cap.
The line may be jammed on the
No
spool. Rewind line to remove
crossed loops. Check that line
is in correct section of spool.
Allow the motor to reach full
No
speed before use
Yes
Rewind line
.
Contact your local approved Serv-
Yes
ice Centre or Husqvarna UK Ltd.
Customer Service.
Only use tip of nylon line to
?
trim.
Rewind the line on the spool, if
Yes
symptoms still persist, change
spool and line.