Do you have a question about the MAXI TRIM 430 - PARTS and is the answer not in the manual?
Questions and answers
Micklawson
May 20, 2025
Need to put a flymo maxi trim 430 carb back together and realign the pipework to connect it
1 comments:
Mr. Anderson
May 24, 2025
To reassemble the carburetor and realign the pipework on a Flymo Maxi Trim 430, follow these steps using the listed parts:
1. Install the Carburetor Gasket (5300191-56/5) between the engine and the carburetor (5300352-59/7). 2. Attach the Carburetor to the engine using appropriate screws (e.g., 5300157-72/3 or 5300157-80/6). 3. Connect the Fuel Filter (5300143-62/4) inside the fuel tank. 4. Fit the Fuel Cap Assembly (5300143-47/5) onto the tank. 5. Ensure the Reed Valve (5300275-93/9) and Reed Stop (5300275-94/7) are correctly positioned if removed. 6. Reattach the Carburetor Pipework: - Connect the fuel line from the tank (with filter) to the carburetor inlet. - Connect the return line from the carburetor to the tank. 7. Check Diaphragms and Gaskets: - Install Pump Gasket (5300351-64/9) and Pump Diaphragm (5300351-66/4). - Install Metering Diaphragm (5300350-14/6) and Metering Gasket (5300351-51/6). - Ensure all small internal parts like the Inlet Needle Valve (5300351-06/0), Springs, and Levers are correctly seated.
Ensure all connections are tight and secure, and no fuel leaks are present.
Need help?
Do you have a question about the MAXI TRIM 430 - PARTS and is the answer not in the manual?
Questions and answers
Need to put a flymo maxi trim 430 carb back together and realign the pipework to connect it
To reassemble the carburetor and realign the pipework on a Flymo Maxi Trim 430, follow these steps using the listed parts:
1. Install the Carburetor Gasket (5300191-56/5) between the engine and the carburetor (5300352-59/7).
2. Attach the Carburetor to the engine using appropriate screws (e.g., 5300157-72/3 or 5300157-80/6).
3. Connect the Fuel Filter (5300143-62/4) inside the fuel tank.
4. Fit the Fuel Cap Assembly (5300143-47/5) onto the tank.
5. Ensure the Reed Valve (5300275-93/9) and Reed Stop (5300275-94/7) are correctly positioned if removed.
6. Reattach the Carburetor Pipework:
- Connect the fuel line from the tank (with filter) to the carburetor inlet.
- Connect the return line from the carburetor to the tank.
7. Check Diaphragms and Gaskets:
- Install Pump Gasket (5300351-64/9) and Pump Diaphragm (5300351-66/4).
- Install Metering Diaphragm (5300350-14/6) and Metering Gasket (5300351-51/6).
- Ensure all small internal parts like the Inlet Needle Valve (5300351-06/0), Springs, and Levers are correctly seated.
Ensure all connections are tight and secure, and no fuel leaks are present.
This answer is automatically generated