IBM 21Y Maintenance Manual page 33

Table 2. Novell NetWare or IntraNetWare ODI driver
messages for the Ethernet controller
PCNTNW-
NW-127
PCNTNW-
NW-164
PCNTNW-
NW-165
PCNTNW-
NW-167
PCNTNW-
NW-180
Network driver interface specification 2.01
(OS/2) driver messages
This section provides explanations of the error messages for
the NDIS 2.01 (OS/2) drivers, and suggested actions to
resolve each problem.
24
Netfinity 3500-M20 – Type 8657 Models 21Y, 22Y, 31Y, 32Y,
The local bit in the node address
override was set.
Explanation: The local bit in the IEEE
address format indicates that the
addresses are being managed locally. If
you use the node address override
capabilities of this driver to enter a new
address, the local bit must be set. You
entered an address without the local bit
set. The driver has set the local bit.
Action: None necessary, message is for
information only.
The device was not found.
Explanation: The driver cannot find an
Ethernet controller in the server.
Action: Verify that the Ethernet controller
is enabled. If the Ethernet controller is
enabled, go to "Starting the diagnostic
programs" on page 11 to run the
diagnostic programs.
The device was not found at
IOADDRESS.
Explanation: The Ethernet controller
cannot be found at the I/O address
specified.
Action: The Ethernet controller does not
require a parameter for the I/O address.
Remove the I/O address parameter.
PCI scan specified, device not found.
Explanation: The driver cannot locate
the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller
is enabled. If the problem persists, go to
"Starting the diagnostic programs" on
page 11 to run the diagnostic programs.
The DMA parameter is not necessary
for PCI device.
Explanation: The Ethernet controller
does not require a DMA setting.
Action: None necessary, message is for
information only.