Advertisement
HD3000 Manual 9/20/02 5:28 PM Page 8
SHUTTING DOWN & CLEAN-UP
Step 1
Step 2
Remove deter-
gent suction tube from con-
off the engine.
tainer and insert into one gallon
of fresh water. Siphon water at
low pressure for one minute.
7
Step 5
Step 6
Press
Disconnect
trigger to release
garden hose from water
water pressure.
inlet on the unit.
TAKING A BREAK... five minutes or more
Step 1
Step 2
Turn off
the engine.
fuel valve to the
off position.
WINTERIZING AND LONG-TERM STORAGE
1. Disconnect all water connections.
2. Start the machine for a few seconds,
until the remaining water exits.
Turn off immediately.
3. Drain the gas and oil from the engine.
4. Do not allow high pressure hose
to become kinked.
Step 3
Step 4
Turn
Slide
fuel valve to the
off water supply.
"OFF" position.
Step 7
Step 8
Disconnect
high pressure hose from
Engage the gun
high pressure outlet.
safety lock.
Step 3
Step 4
Slide
Press
trigger to release
gun safety lock.
water pressure.
5. Store the machine and accessories in
a room which does not reach freezing
temperatures.
Caution: Failure to follow the above
directions will result in damage to the
pump assembly and accessories.
CLEANING TIPS
Deck Cleaning
(with or without detergent)
Pre-rinse deck and surrounding area with
fresh water. If using Kärcher Deck Wash,
place detergent suction tube directly into
cleaning solution and apply to surface at
low pressure. For best results, limit your
work area to smaller sections of
approximately 25 square feet. Allow
Turn
Kärcher Deck Wash to remain on surface
1-3 minutes. Do not allow detergent to dry
on surface. Rinse at high pressure in a long
sweeping motion keeping the spray nozzle
approximately 3-6 inches from the cleaning
surface. Always clean from top to bottom
and from left to right. When moving on to
a new section of the cleaning surface, be
sure to overlap the previous section to
eliminate stop marks and ensure a more
even cleaning result.
Caution: Do not use Dirtblaster
on wood surface as it may cause
damage.
House Siding
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
If using Kärcher House Wash, place
detergent suction tube directly into cleaning
solution and apply to surface at low
pressure (for best results, limit your work
area to sections of approximately 6 feet
and always apply detergent from bottom to
top). Allow Kärcher House Wash to remain
on surface 1-3 minutes. Do not allow
detergent to dry on surface, if surface
appears to be drying, simply wet down
Engage
surface with fresh water.
If needed, use special Wash Brush
Attachment to remove stubborn dirt.
Rinse at high pressure from top to bottom
in an even sweeping motion keeping the
spray nozzle approximately 6 inches from
the cleaning surface.
Caution: Do not use Dirtblaster
on siding as it may cause damage.
Cement Patios,
Brick and Stone
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
If using Kärcher All Purpose Cleaner, place
detergent suction tube directly into cleaning
solution and apply to surface at low
pressure. For best results, limit your work
area to smaller sections of approximately
25 square feet. Allow Kärcher All Purpose
Cleaner to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface.
Rinse at high pressure in a sweeping
motion keeping the spray nozzle
approximately 3-6 inches from the cleaning
surface. Always clean from top to bottom
and from left to right. For removing
extremely stubborn stains, use Kärcher
Dirtblaster
®
Nozzle.
®
nozzle
Cars, Boats & Motorcycles
(with or without detergent)
Pre-rinse vehicle with fresh water. If using
Kärcher Vehicle Wash, place detergent
suction tube directly into cleaning solution
and apply to surface at low pressure.
For best results, clean one side of vehicle
at a time and always apply detergent from
bottom to top, do not allow detergent to
dry on surface. Rinse at high pressure in a
sweeping motion keeping the spray nozzle
approximately 6-8 inches from the cleaning
surface (distance should increase when
rinsing pin-striping or other sensitive
surfaces). Always clean from top to bottom
and from left to right. For best results,
wipe surface dry with a chamois or
soft dry cloth.
Caution: Do not use Dirtblaster
on vehicles as it may cause damage.
®
nozzle
8
®
nozzle
Advertisement
