Lexmark X203n Servise Manual page 41

Fax error log codes (Continued)
Error code Description
80B Too many errors when transmitting in
ECM mode.
80C Remote device failed to respond to the
CTC command.
80D Received too many requests from
remote end to repeat the previous
command sent.
80E Functional limitation- Remote fax
device does not support G3 receive
capability.
811 Failed to detect a fax device at the
remote end.
812 No more data rates available in V34
modulation scheme.
813 Timeout occurred after waiting too long
to receive a good frame.
814 Tried too many times at selected speed
using V34 modulation scheme.
815 Fax transmission was interrupted due
to power failure.
818 Fax transmission failed due to
insufficient memory to store scanned
image.
819 Fax transmission failed due to
insufficient memory to store received
image.
81A A timeout occurred during transmission
of a page in ECM mode.
880 Failure to transmit training successfully
in V17, V29, V27 terminal modulation
schemes.
882 Failure to transmit training successfully
in V17, V29 terminal modulation
schemes.
883 Failure to transmit training successfully
in V17,V27 terminal modulation
schemes.
Action
• Check line quality.
• Adjust 'Transmit Level'.
• Select a lower 'Max Speed'value under
Fax Send setting's.
• Select a lower 'Max Speed' value
under Fax Send setting's.
• Adjust 'Transmit Level'.
• Check line quality.
• Adjust 'Transmit Level'.
• Check if line conditions on remote end
will facilitate a good connection.
No action needed. Issue with the remote
device.
• Verify MFD is answering to fax call and
not a voice call.
• Decrease value of 'Rings To Answer'
setting.
• Adjust to a lower modulation scheme.
• Adjust "Receive Threshold".
• Adjust 'Transmit Level'.
• Adjust to a lower modulation scheme.
• Troubleshoot MFP if error persists. See
"Modem service check" on
page 2-29.
Adjust 'Memory Use' setting to allocate
more memory for send jobs.
Adjust 'Memory Use' setting to allocate
more memory for receive jobs.
Select a lower 'Max Speed' value under
Fax Send setting's.
• Select a lower "Max Speed" under Fax
Send setting's.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send setting's.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send setting's.
• Adjust the "Transmit Level".
• Check line quality.
Diagnostic information
7011-2xx / 3xx
2-15