Set The Protocol - GE CyberDome II Installation Manual

26 CyberDome II
Installation Manual

Set the protocol

CyberDome II can use different protocols for communication. To use a protocol, you must set the DIP switches
according to the protocol you want to use (Figure 15). Use the information in Table 6 to set the DIP switches
for the desired protocol.
Figure 15. Protocol switch
Table 6. Protocols
Protocol
Automatic selection
Digiplex 4800
Impac 9600
ASCII 9600
Pelco D Autobaud
Pelco P 4800
Ultrak 9600
BBV
Copy settings from PTZ to housing
Copy settings from housing to PTZ
a. The Automatic selection will automatically determine only the GE protocols (Digiplex, Impac, and ASCII).
CyberDome II stores all programming information settings in nonvolatile memory in both the housing and in the PTZ. If the
protocol switches are in any other configuration and the two memories are different, you will see Memory flashing onscreen, and
when you first log onto the menu system, you will be asked which settings you would like to use.
a
Switch position (1 = on, 0 = off)
00000
10000
01000
11000
00100
10100
01100
01110
01111
11111
Protocol switch