Kenmore 116.34924 Owner's Manual page 8

To select a pile height setting:
Turn off vacuum cleaner. Select a pile height
setting by tilting the cleaner back until front
wheels are lifted slightly off the floor.
Slide the adjustment lever to the correct
setting.
There are four (4) pile height settings on the
vacuum cleaner. Use the LOW setting for
most low-pile carpets and bare floor
cleaning (with agitator OFF), and the HIGH
setting for high-pile carpets like shag carpet,
scatter rugs, etc. Use the other settings as
needed for carpet heights in-between low
and high pile.
Height
Adjustment
Lever
\
CAUTION
Do not allow vacuum cleaner to
remain in one spot for any length of
time when the agitator is turning.
Damage to carpet may occur.
Crevice
Tool _
Telescoping
Wan_
-Stretch
Dusting Hose
Combination Hose
Collar
Identify each of the attachments shown
above.
TO USE ATTACHMENTS
Remove the lower end of the stretch hose
from the vacuum cleaner by grasping the
hose collar, press the release button and
pull straight out. The attachments can now
be added to the hose.
NOTE: The motor protector may open when
using attachments or when cleaning new
carpet, due to reduced airflow caused by the
attachments themselves or by new carpet
lint filling the bag quickly. See the
TROUBLESHOOTING section.
!
TV.. WARNING
Electrical Shock And Personal Injury
Hazard
Disconnect electrical supply before
performing maintenance to the uniL
Failure to do so could result in elec-
trical shock or personal injury from
vacuum cleaner suddenly starting.
8