Installation - Bunn sure tamp steam Installation & Operating Manual

Drain Install
1. Attach the short drain hose to the drip tray fi tting.
2. Slide drip tray onto guide rails on front of machine.
3. Attach other end of drain hose to manifold as shown.
4. Attach long drain hose to back of manifold and route to
fl oor drain or sink, fl owing downhill at all times.
5. Secure hose above the drain to maintain the air gap.
Water Supply Install
1. Ensure water is turned off.
2. Install the water fi ltration system between the water sup-
ply and the machine inlet per manufacturer's installation
recommendations.
3. Connect one end of the inlet hose assembly to the adapter
and the other end to the water supply.
4. Turn on the main water supply. Check for leaks; if necessary
resolve leak issues before proceeding.
Electrical Install
WARNING – Improper electrical installation will damage elec-
tronic components.
1. Determine the available electrical service.
2. Ensure the proper voltage at the electrical source.
3. Uncoil the cord completely and install the cord cap (not
supplied) to the power cord. Black (L1) and red (L2 or N)
and green (ground).
4. Plug securely into the outlet.

INSTALLATION

INSTALL DRAIN HOSE AND DRIP TRAY
INSTALL DRAIN HOSES TO MANIFOLD
Page 5
INSTALL WATER SUPPLY LINE
45921 112812