Installing Or Replacing The Optical Drive - Lenovo ThinkStation 4215 Hardware Maintenance Manual

6. Position the new memory module over the memory slot. Make sure that the
Figure 13. Installing a memory module
7. Reinstall the PCI Express x16 graphics card if you have removed it.

Installing or replacing the optical drive

This section provides instructions on how to install or replace the optical drive.
To install or replace an optical drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the
2. Remove the computer cover. See "Removing the computer cover" on page 87.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on
4. Depending on whether you are installing or replacing an optical drive, do one
94
Hardware Maintenance Manual
notch 1 on the memory module aligns correctly with the slot key 2 on the
system board. Push the memory module straight down into the slot until the
retaining clips close.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the installation or replacement, go to "Completing the FRU
replacement" on page 122.
Attention
Do not open your computer or attempt any repair before reading and
understanding the "Important safety information" in the ThinkStation Safety
and Warranty Guide that came with your computer. To obtain a copy of the
ThinkStation Safety and Warranty Guide, go to:
http://www.lenovo.com/support
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
page 89.
of the following:
v If you are installing a secondary optical drive, remove the plastic panel in the
front bezel for the drive bay you want to use. If there is a metal static shield
installed in the drive bay, remove the metal static shield.