Installing Or Replacing An Optical Drive - Lenovo ThinkStation P310 User Manual

7. Position the new memory module over the memory slot. Ensure that the notch
module is aligned with the key
the retaining clips completely close.
Figure 21. Installing a memory module
8. Reinstall the PCI Express x16 graphics card if you have removed it.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 105.

Installing or replacing an optical drive

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
Note: For some computer models, the optical drive bay might be installed with a device such as an
optical drive, a 5.25-inch flex module, a flex storage enclosure, a front-access storage enclosure, or an
optical/storage combination enclosure.
To install or replace an optical drive, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 58.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 59.
4. If you are installing an optical drive, do the following:
a. Remove the metal static shield from the desired drive bay.
66
ThinkStation P310 User Guide
2 in the slot. Push the memory module straight down into the slot until
1 on the memory