Change The Presser Foot - Kenmore SWA/RS 10101 Owner's Manual

I
/
Change the presser foot
Snap-on presser feet
1. Bring the needle to the up position.
2. Raise the presser foot lever.
3. Push the foot release lever and the presser
foot will drop off.
4. Place the new foot on the needle plate
aligning needle holes.
5. Lower the presser foot lever so that the
presser foot holder snaps on the foot.
6. Push down the presser foot thumb screw
to engage the foot holder and the foot
securely.
Screw-type presser feet
To use some accessory feet (see page 6), you
may need to remove the presser foot holder.
1. Bring the needle to the up position.
2. Raise the presser foot lever.
3. Turn the presser foot thumb screw toward
the back of the machine using the large
screw driver.
4. Remove the presser foot holder.
5. Insert the new foot.
6. a. Lower the presser foot lever.
b. Tighten the thumb screw using the
screw driver to fit the foot securely.
Presser
foot
holder
!
Foot
release_,_
lever
Foot hold_
Foot
thumb
screw
I
19