Select Options - Asko W6424W Operating Instructions Manual

Operating instructions
6

Select options

You can select options to adjust the wash
program to suit your own specific
requirements. The available options depend on
the selected program. If the option is available
for the selected program, the symbols lights up
when you press the button.
The machine will remember the options you
select for each program (with one exception –
Delayed Start). You can still change the selected
options the next time you select a particular
program.
Temperature
• Select the temperature by pressing the button
until the LED by the correct temperature lights.
• You can select temperatures between 68 °F
(20 °C) and 203 °F (95 °C). You cannot choose
a temperature higher than 104 °F (40 °C) for
Wool/Hand Wash. The maximum temperature
for Perma Press or Everyday Wear (Easy care)
is 140 °F (60 °C).
Spin
• Select the spin speed by pressing the button
until the LED by the correct speed lights.
• You can select speeds between 400 and 1200
rpm, No spin, or No drain. The maximum
spin speed varies according to the selected
program, so check the LEDs around the
button.
• , means that the program does not include
a spin cycle and ends by draining.
• No drain means that the program does
not include a spin cycle and ends with the
water from the final rinse still in the machine.
105˚ 205˚ 400
85˚ 140˚
Cold 120˚
Customer Care Center
1-800-898-1879
www.askona.com
1200
1000
800
The washing will remain covered by the water
from the final rinse, stopping it from getting
wrinkled. If you have selected "No drain", you
must select the Spin & Drain program and the
symbol (no spin) once the program has
ended to drain the water from the machine
before you open the washer door.
Super Rinse
Use the Super Rinse option if you want to
increase the number of rinses. The maximum
number of rinses is seven and varies depending
on the selected program. Recommended for
persons with extremely sensitive skin and/or in
areas with very soft water. This option cannot be
selected with Quick, Rinse, or Spin & Drain.
• Select Super Rinse by pressing the button
under the symbol.
• An LED next to the button lights when this
option is activated.
Delayed start
When you select Delayed Start, the machine will
start 1-24 hours after you press the Start/Stop
button.
• Press the button by the symbol to activate
Delayed Start.
• By pressing the button again, you can delay
the start in whole hours up to a maximum of
24 hours.
• Press Start/Stop and the machine will count
down 1 hour at a time, starting after the
selected delay.
If you change your mind and want to cancel
Delayed Start, press and hold Start/Stop for
three seconds.
19