Video Boards - HP 9000 Series 310 Service Information Manual

Video Boards
Video boards are located in one of the system slots, usually the top one. Instructions listed
below do not apply to the video cards installed in the accessory slots.
Preliminary Requirements
1. Turn the computer off.
2. Remove the power cord.
Procedures
1. Disconnect the video cables frorTI the video board.
2. Using a flat tip screwdriver or your finger tips, unscrew the two captive screws holding
the video board in its system slot.
3. Remove the video board.
4. To install the video board, reverse steps 1, 2, and 3.
I/O Cards
Preliminary Requirements
1. Turn the computer off.
2. Remove the power cord.
Procedures
1. Disconnect the I/O cables from the I/O card.
2. Using a flat tip screwdriver or your finger tips, unscrew the two captive screws holding
the I/O card in the computer's backplane.
CAUTION
Some accessories consist of two assemblies connected together by rib-
bon cables. Do not completely remove these accessories with the panel
on it until the cable has been disconnected. When reassembling these
assemblies, sets, insert the top assembly first, then insert the lower one
before connecting them together.
3. Remove the I/O card from its I/O slot.
NOTE
Before installing I/O cards, ensure they are correctly configured for the
application and/or peripherals.
4. To install the I/O card, reverse steps 1, 2, and 3.
28
Assembly Replacement