Assembly Replacement Procedures
Overview
In this sectioll, procedures are listed for removing and installing each assembly. For each assem-
bly, a list of Preliminary Requirements is listed. To perform these Preliminary Requirements,
follow the steps shown in each Preliminary Item's replacement procedure.
Instructions are based on the following orientation of the hardware:
• The right side is the side on your right as you face the front of the unit. For example, the
Power-On LED is on the unit's right side.
• The left side is the side on your left as you face the front of the unit. For example, the
power supply is on the unit's left side.
• The front is the end toward you as you face the front panel. For exalnple, the power
switch is
OIl
the unit's front end.
• The back is the end away from you as you face the front panel. For example, the fuse is
on the unit's back end.
• The top and bottom are relative to their normal positions.
These references are used in the procedures and should be followed regardless of how you are
facing the unit. Figure 2-2 shows the hardware orientation.
Back
J
Right Side
I
...
: ' :
...........................
,
......... .
Figure 2-2. Hardware Orientation
26
Assembly Replacement