2000-Sheet Dual Input (Ttm)-Clutch Removal - Lexmark W840 Service Manual

4024-XXX
2000-sheet dual input (TTM)—clutch removal
1.
Remove the rear cover. See
2.
Disconnect the connector from the machine to the bracket (A).
3.
Remove two screws securing the bracket (A) to the frame assembly.
4.
Remove the bracket (A).
Note: The bushing (B) and washer (C) may become detached from the shaft (D).
5.
Remove the e-clip securing the clutch gear - 38 tooth (E) to the shaft (D) using a prying tool, and remove
the clutch gear - 38 tooth (E).
6.
Disconnect the harness connector to the 2TM/TTM clutch (F) from the bracket (A).
7.
Remove the 2TM/TTM clutch (F).
Connector
Note: Before re-installing:
–
The notch on the 2TM/TTM clutch (F) must be placed over the boss of the bracket (A), as shown in
the figure.
–
Ensure the harness does not come in contact with the gears.
4-118
Options Service Manual
"2000-sheet dual input (TTM)—rear cover removal" on page
Knotch
B
A
Boss
E
E-ring
Rear
C
B
E-ring
D
F
4-51.