Belling GHU60-70 AU User Manual page 17

adjacent heat source, such as an oven
.
grill or hob.
Ensure that all pipe work is of the
correct rating for both size and
temperature.
Means of isolation shall be provided
connect to the gas supply
at the shut off point by either an
Means of isolation shall be provided at the
approved quick connect device or a
shut off point by either an approved quick
Type 1 manual shut off valve. The
connect device or a Type 1 manual shut
outlet of the quick connect device
off valve. The outlet of the quick connect
e
device shall be at, or below, the horizontal
shall be at, or below, the horizontal
t
position.
position.
s
Connection to the gas supply should
Connection to the gas supply should be
f
made using the Aquaknect AS/NZS 1869
be made using the Aquaknect
t
class B hose assembly with an internal
AS/NZS 1869 class B hose assem-
d
diameter of not less than 10mm and
bly with an internal diameter of not
h
regulator (regulator for use with natural
less than 10mm and regulator (regu-
gas)
;
lator for use with natural gas)
NOTE: Maximum length of hose 900mm.
NOTE: Maximum length of hose The temperature rise of the areas at the
e
rear of the cooker that are likely to come
900mm. The temperature rise of the
.
into contact with the flexible hose do not
areas at the rear of the cooker that
o
exceed 70˙C.
are likely to come into contact with
e
The inlet to the cooker is ½" BSP internal
the flexible hose do
e
situated at the rear right corner. Fit the
70˙C.
bayonet connection. This should be
located so as to ensure that the flexible
24
connector hose does not kink.
under no circumstances should the flexible
connector be allowed to come into contact with
the vertical oven flue tubes on the rear of the
appliance.
Use a 900mm - 1125mm length of
flexible connector.
Ensure that all pipework is of the correct
rating for both size and temperature.
InstallatIon InstructIons - gas products
not exceed
after installation, make sure all connections
are gas sound.
commissioning
Burner aeration
All burners have fixed aeration and no
adjustment is possible.
pressure setting
Natural Gas @ 1.00kPa
Propane Gas @ 2.75kPa
pressure test point
Use a hob injector.
Connect to the electricity supply
Unless this appliance is supplied with a fitted plug,
it must be connected by a competent person, using
fixed wiring via a double pole switched fused spur outlet,
with a contact separation of 3mm at all poles.
Connect the mains lead wires to the terminals:
The blue wire must be connected to the terminal marked
N(Neutral) LOAD or coloured black.
The brown wire must be connected to the terminal marked
L(Live) LOAD or coloured red.
The green/yellow coloured wire must be connected to the
terminal marked E(Earth) or coloured green.
Warning: this appliance must be earthed.
The fused spur must be accessible after installation.
If the supply cord is damaged, obtain a special cord from
the Customer Care Helpline, which must be fitted by
a qualified person.
Hob burner - Turn the control knob to the
FULL ON position, wait a second before
pressing the ignition switch or holding a
lighted match or taper to the burner. Hold
the control knob in for 15 seconds. Do not
hold the control knob in for longer that 15
seconds. If the burner fails to light within
this time, release the control knob and
wait one minute before attempting further
ignition.