Clean Your Refrigerator
Thoroughly Twice A Year
Always remove the power cord fi'orn the wall outlet when cleaning in
the vicinity.of electrical parts (bulb, switch, control, etc.).
Use a mild detergent or baking soda and water.
How To Clean The Inside
1. Turn the Cold Control to "OFF". UNPLUG THE POWER
CORD FROM THE WALL OUTLET.
Remove food from the section or sections to be cleaned. Pack
frozen food in a picnic chest or cardboard box or wrap in
several thicknesses of newspaper so it will remain frozen.
Take out removable parts and wash with a mild detergent,
rinse and wipe dry.
Wash the inside with two tablespoons of baking soda mixed
in one quart of warm water. If necessary, use soap or mild
detergent and water. Rinse well and dry.
(l) Strong detergents, scouring powder or pads, will crack the
plastic. Do not use them. (2) Do not wash any parts in a
dishwasher unless marked "dishwasher safe." (3) Do not clean
with ammonia or bleach type chemicals which will damage
your cooling unit.
How to Clean the Outside
Exterior Cabinet: Use a mild detergent or soap solution and
rinse well. Do not use scouring powder or pads.
In some climates it may be advisable to help protect the cabinet
finish by waxing it. Use a good quality automotive type wax,
taking care not to wax any plastic parts.
How to Clean theEvaporation
Since dust accumulated on the evaporation tray will decrease
the evaporation efficiency, remove the tray and clean it.
Clean The Condenser
The condenser (tubing and wire attachment) is on the back of
the refrigerator. Clean it with a vacuum eleanex. Do not bend or
twist the tubes. If you have moved the refrigerator, make sure
the doors seal tightly. If they don't, level the refrigerator.
Before going on any long vacations, remove all perishables
such as fresh meats, milk, eggs, butter, fruits and vegetables.
Anytime you won't be using your refrigerator regularly, for an
extended period of time or are putting it into storage, empty and
unplug it. Clean the evaporation tray. Clean inside and block the
doors open. Air moying through your refrigerator will help
With the freezer-refrigerator
in operation, it is possible that the
cabinet will feel warm at the front edges. This does not indicate
trouble. It is attributable to the hot-line design adopted for this
which consists of piping hot gas from the
(motor-driven) compressor along the front edges of the cabinet
This has nothing to do with the storage temperature inside.
The evaporation tray is set on refrigerator back. To remove,
unscrew and pull it out.
Replace the evaporation tray by following the removal
instructions in reverse and be sure to secure it properly.
If the tray is not securely in place, defrosted water may spill out
or the evaporation process may be hindered.
Save the Servicing
Technical servicing information is attached under the back of
the refrigerator. Please, do not remove this information. It may
someday assist your serviceman should repairs be required.