Preparing The Radio 4; Radio Battery Installation 4; Radio Operation 4 - THUNDER TIGER 6540-F Instruction Manual

3
PREPARING THE RADIO
a
a. Install the antenna into transmitter.
b. Check the frequency printed on the transmitter crystal.
c. Check the frequency printed on the receiver crystal, and make sure it matches with the transmitter crystal. Make sure no one will
operate on the same frequency when you are. When there is a radio glitch, it will most likely be caused by improper crystal, damaged
crystal, or people operating on the same frequency.
a.
b.
c.
4
RADIO BATTERY INSTALLATION
a
a. Install 8 AA-size alkaline batteries into transmitter.
b. Install the power pack (stick type battery pack shown in the picture) and connect to the ESC. (6607)
Caution: Check all the wiring and connections before you connect the speed control to a drive battery. Incorrect polarity
will wreck your speed control.
a.
b.
5
RADIO OPERATION
a
a. When turning radio on, first turn on the transmitter.
b. Then, turn on the ESC. When turning off, first turn the ESC off, then the transmitter off.(6667)
c. To reverse the functions of servos, use the small, white servo reverse switches located on side of the pistol transmitter (or the
inset servo reverse switches located at the bottom of the stick transmitter). To trim the servos on pistol transmitter, use the trim
switches on side of the steering wheel (the ST. trims steering, and the TH trims throttle/brake). On a stick transmitter, the trim
levers are located accordingly around the sticks.
Caution: Do not run flat the battery of your transmitter in case of losing control of the car. For more details, please check
the transmitter instruction manual.
a.
b.
c.
b
b
7.2V
b
b
c
R
c