THUNDER TIGER TS-4N PRO V.2 Manual
  1. Manuals
  2. Brands
  3. THUNDER TIGER Manuals
  4. Motorized Toy Car
  5. TS-4N PRO
  6. Manual

THUNDER TIGER TS-4N PRO V.2 Manual

1/10 nitro powered 4wd touring car
Hide thumbs Also See for TS-4N PRO V.2:
Table of Contents

Advertisement

Quick Links

See also: Manual
1/10 NITRO POWERED 4WD TOURING CAR
No.6167-F
JD6221
Thunder Tiger Corporation guarantees this model kit to be free from defects in both material and workmanship.
The total monetary value under warranty will in no case exceed the cost of the original kit purchased. This warranty
does not cover any components damaged by use or modification. Part or parts missing from this kit must be
reported within 60 days of purchase. No part or parts will be sent under warranty without proof of purchase.
To receive part or parts under warranty, the service center must receive a proof of purchase and/or the defective
part or parts. Should you find a defective or missing part, contact the authorized Thunder Tiger Service/Distributor
nearest you. Under no circumstances can a dealer or distributor accept return of a kit if assembly has started.

Advertisement

Table of Contents
loading

Related Manuals for THUNDER TIGER TS-4N PRO V.2

Summary of Contents for THUNDER TIGER TS-4N PRO V.2

  • Page 1 No.6167-F JD6221 Thunder Tiger Corporation guarantees this model kit to be free from defects in both material and workmanship. The total monetary value under warranty will in no case exceed the cost of the original kit purchased. This warranty does not cover any components damaged by use or modification. Part or parts missing from this kit must be reported within 60 days of purchase.

  • Page 2: Items Supplied

    INTRODUCTION Thank you for the purchase of this Thunder Tiger product. You should enjoy many hours of trouble free use from this advanced R/C product. Thunder Tiger strives to bring you the highest level of quality and service we can provide. We race and test our products around the world to bring you state-of-the-art items.
  • Page 3 INSTALLING THE RADIO GEAR skip if already assembled Disassemble the roll bar. Remove the 8 screws on the radio plate and two 3*10mm countersunk screws on the chassis. Install the steering / throttle servos onto the mounts with four tap screws. Notice the orientation of the throttle / steering servo output shafts.

  • Page 4: Charging The Glow Plug Igniter

    Install the servo horn onto throttle sero output shaft. CHARGING THE GLOW PLUG IGNITER Thunder Tiger Optional Part #2165, 1300MAH Glow Starter w/220V Charger. Thunder Tiger Optional Part #2166, 1300MAH Glow Starter w/110V Charger. Plug the charger into an AC outlet, and then pull on the igniter lever to accept the charging adapter.

  • Page 5: Preparing The Radio

    PREPARING THE RADIO Install the antenna into transmitter. Check the frequency printed on the transmitter crystal. Check the frequency printed on the receiver crystal, and make sure it matches with the transmitter crystal. Make sure no one will operate on the same frequency when you are. When there is a radio glitch, it will most likely be caused by improper crystal, damaged crystal, or people operating on the same frequency.

  • Page 6: Operating Radio Steering Function

    OPERATING RADIO STEERING FUNCTION Check the radio steering functions. With the radio transmitter and receiver on, turn the steering wheel/stick to the left. The front tires/wheels should turn left accordingly. If not, flip the steering servo reverse switch. Return the steering wheel/stick to neutral. The front tires/wheels should point straight forward. If not, use the steering trim lever to correct it.

  • Page 7: Adjusting Throttle / Brake Linkage

    ADJUSTING THROTTLE / BRAKE LINKAGE To set the throttle/brake linkage, first the radio should be on and neutral; thus, the servo is at neutral position. With the servo at neutral, turn and adjust the brake adjust knob to a point where the brake lever almost engages the brake system, but not yet.

  • Page 8: Preparing The Engine

    (replace with new one). After checking, reinstall the glow plug. The glow plug used for this engine can be: Thunder Tiger 9281, McCoy #9 / #59, Novarossi C4S / C5S / C6S,OS #8 / #A3 / #A5, and Picco P6S / P7S.

  • Page 9: Starting The Engine

    STARTING THE ENGINE Turn on the radio (transmitter first, then receiver). Clip the glow plug igniter onto engine's glow plug. Pull on the engine starter, release, repeat until the engine starts. Throttle maybe required to be opened momentarily, but release throttle back to neutral immediately after the engine starts. Remove the glow plug igniter from engine after engine has started and warmed up.

  • Page 10: Engine Break-In/Setting

    Also, check your radio for proper operation before operating a mode. 6. Improper operations may cause personal and/or property damage. Thunder Tiger and its distributor have no control over damage resulting from shipping, improper construction, or improper usage.
  • Page 11 SET-UP By setting different adjustments on your TS-4N car can help you obtaining improved steering, traction, and the handling for different LESS STEERING track conditions. FOR SMOOTH TRACK STANDARD FOURTH HOLE STANDARD MORE STEERING FROM THE FRONT LESS STEERING LOOSEN BELT TIGHTEN BELT LESS STEERING, MORE CLIP...
  • Page 12 Titanic color anodized chassis, 2-CHANNEL RADIO 2 speed system Metal shock absorbers Full ball bearings equipped PRO-12BXS DODGE VIPER GTS-R PEUGEOT 206 FORD FOCUS BENZ AMG C32 BMW M3 GT SUBARU IMPREZA WRC OPEL ASTRA V8 Thunder Tiger Corporation http://www.thundertiger.com...

This manual is also suitable for:

6167-f

Table of Contents