Preparing The Radio; Radio Battery Installation; Radio Operation - THUNDER TIGER uno Instruction Manual

PREPARING THE RADIO

5
a
a
a.
Check the frequency printed on the transmitter crystal.
b.
Check the frequency printed on the receiver crystal, and make sure it matches with the transmitter
crystal. Make sure no one will operate on the same frequency when you are. When there is a radio
glitch, it will most likely be caused by improper crystal, damaged crystal, or people operating on the
same frequency.
c.
Install the antenna into transmitter.
6

RADIO BATTERY INSTALLATION

a
a.
Install 8 AA-size alkaline batteries into transmitter.
b.
Undo the large zip-tie, and remove the receiver battery box. Install 4 AA-size alkaline batteries into
receiver battery box.
c.
Reinstall the battery box on the battery mount and tie with the receiver.
7

RADIO OPERATION

a
a.
When turning radio on, first turn on the transmitter.
b.
Then, turn on the receiver. When turning off, first turn the receiver off, then the transmitter off.
c.
To reverse the functions of servos, use the small, white servo reverse switches located on side of the
pistol transmitter (or the inset servo reverse switches located at the bottom of the stick transmitter). To
trim the servos on pistol transmitter, use the trim switches on side of the steering wheel (the ST. trims
steering, and the TH trims throttle/brake). On a stick transmitter, the trim levers are located accordingly
around the sticks.
For more details, please check the transmitter instruction manual.
b
b
b
4
c
c
c
c