Programming the Remote Control
POWER TV POWER
TOP MENU MENU
The remote control is preset to operate Sony brand video equipment.
Follow the steps below to program your TV's remote control to operate the
non-Sony video equipment.
Find the three-digit code for your equipment from the "Manufacturer's
Codes" listed on page 48. If more than one code number is listed, try
entering from the code listed first.
1 Press and hold the
program on the remote control and press the
2 Enter the three-digit manufacturer's code number using the --9
buttons while the button is lit. If code is not entered within 10 seconds,
you must perform step 1 again.
When the programming is correct, the selected
flash twice, and when not, flashes five times.
To check if the code works
Aim your TV's remote control at the equipment, and press the green
button. If the equipment turns on and off, the programming is completed. If
not, try the next code listed.
If no code is input within the above specified time, or an invalid or
incorrect code number is input, the remote control automatically
goes back to the previous setting.
In some cases, you may not be able to program your remote
control to operate other equipment. In such cases, use the
equipment's own remote control.
Using dead batteries or removing the batteries may cause the
programmable codes to be lost and revert back to factory settings.
Reprogramming the codes may be necessary.
Programmable Code Number
601 (Sony Dream System)
801 (Sony Satellite Receiver)
button (DVR, DVD/VCR or SAT/CABLE)
Watching the TV
button you want to