Tv Controls And Connectors; Front Panel - Sony KDF-E42A10 Service Manual

TV Controls and Connectors

Front Panel

WEGA GATE
TV/VIDEO
1 2
Item Description
1 WEGA GATE Press to display WEGA GATE and activate the
WEGA GATE and activate the TV/VIDEO, – VOLUME + and – CHANNEL+ buttons.
2 Press to confirm the selection or setting.
Press repeatedly to cycle through the video equipment connected to the TV's video inputs.
TV/VIDEO
3 Press to adjust the volume.
– VOLUME +
4 Press to scan through channels. To scan quickly through channels, press and hold either – or +.
– CHANNEL +
5 TIMER LED When lit, indicates one of the timers or Sleep is set. When it is set, this LED will remain lit even if
the TV is turned off. For details, see page 83.
6 LAMP LED
Lights up in red when the lamp for the light source has burned out. For details, see "Replacing the
Lamp" on page 86.
7 POWER/
Lights up in green when the TV is turned on. If the LED blinks in red continuously, this may
indicate the display unit needs servicing (see "Contacting Sony" on page 2). When the red LED
STANDBY LED
blinks only three times, the lamp door of the lamp unit or the lamp itself is not securely attached
(see page 88).
8 (IR) Infrared
Receives IR signals from the remote control.
Do not put anything near the sensor, as its function may be affected.
Receiver
9 POWER
Press to turn on and off the TV.
q; Speaker Outputs audio signal.
✍
WEGA GATE
TV/VIDEO
PUSH OPEN
VOLUME CHANNEL
3 4
The CHANNEL + button has a tactile dot. Use the tactile dot as a reference
when operating the TV.
TIMER LAMP POWER/STANDBY POWER
PUSH OPEN
0
VOLUME CANNEL
TIMER LAMP
5 6
B b v
, , ,
Introducing the TV
To open the panel
To open the front panel of your
TV, push up the panel door just
under the "PUSH OPEN" mark.
POWER/STANDBY
POWER
7 8 9
V
, and buttons. Press again to exit
15