Power Control; Power Control For Av Source; Power Control For Pc Source - Sharp LC-32G2X/ TU-32GAX Operation Manual

Basic adjustment settings

Power control

Power control setting allows you to save energy.

Power control for AV source

No Signal off
When set to "Enable", the power will automatically shut
down if no signal inputs for 15 minutes.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Power control".
• Power control menu displays.
3
Press a/b to select "No Signal Off", and
then press ENTER.
4
Press c/d to select "Enable", and then
press ENTER
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.
• When a TV programme finishes, and the AVC System
receives signal input, this function may not operate.
No Operation off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Power control".
• Power control menu displays.
3
Press a/b to select "No Operation Off", and
then press ENTER.
4
Press c/d to select "Enable", and then
press ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.

Power control for PC source

Power control setting allows you to save energy.
Power management
When set, the power will automatically shut down.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Power control".
• Power control menu displays.
3
Press a/b to select "Power Management",
and then press ENTER.
4
Press a/b to select "Mode1" or "Mode2",
and then press ENTER.
Selected item
• No power management
Off
• Factory preset value.
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the System stays off.
Mode1
• The System turns on again by pressing
POWER. (See page 19.)
• If no signal inputs for 8 seconds, the power
shuts down.
• When you start using the PC and the signal
Mode2
inputs again, the System turns on.
• The System turns on again by pressing
POWER. (See page 19.)
Off
Mode1
Mode2
Description
35