Setting The System - Sharp LC-32G2X/ TU-32GAX Operation Manual

Preparation

Setting the System

After putting the Display and the AVC System in place, connect the system cables and AC cords. Use the
cable clamps for bundling the cables.
1
Removing the terminal cover
2
Connecting the system cable and the AC cord to the Display
3
Connecting the system cable and the AC cord to the AVC System
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
Display (rear view)
AC cord
* Check the alignment of the
terminals before inserting.
AVC System (rear view)
(WHITE)
Connect the plug into the
terminal and secure it by
tightening the thumb screws.
(BLACK)
System cable
System cable
(BLACK)
AC cord
Press the two hooks
toward the centre of the
Display and remove the
cover toward you.
Press down the two
upper hooks to remove
the cover toward you.
(GREY)
Connect the plug firmly
until the hooks on both
sides click.
(WHITE)
(GREY)
9