Power Control - Sharp LC-26G4U Operation Manual

Table of Contents

Advertisement

Basic adjustment settings
Power control setting allows you to save energy.
No signal off
When set to "Enable", the power will automatically shut
down if no signal inputs for 15 minutes.
Power control setting allows you to save energy.
Power management
When set, the power will automatically shut down.
Repeat steps 1 and 2 in No signal off.
Press MENU and the MENU screen displays.
Press
~/T
to select "Power Management",
and then press ENTER.
• If no signal inputs for 8 minutes, the power
shuts down.'
• Even if you start using the PC and the signal
inputs again, the TV stays off.
• The TV turns on again by pressing TV
POWER on the remote control unit. (See
page 18).
• No power management
• Factory preset value.
Press
~/T
to select "Mode1" or "Mode2",
and then press ENTER.
Off
Mode1
• Five minutes before the power shuts down,
remaining time displays every minute.
Press
~/~
to select "Enable", and then
press ENTER.
Press
~/~
to select "Power Control".
Press
~/T
to select "No Signal Off", and
then press ENTER.
• "Disable" is factory preset value.
• When a TV program finishes, this function may not operate.
No operation off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
Mode2
• If no signal inputs for 8 seconds, the TV
enters standby mode.
• When you start using the PC and the signal
inputs again, the TV turns on.
Repeat steps 1 and 2 in No signal off.
Press
~/T
to select "No Operation Off", and
then press ENTER.
Press
~/~
to select "Enable"" and then
press ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
• When using a digital PC and setting "Mode2" in Power
management, the power may not turn back on
automatically even if the signal inputs again.
• If you turn off the power by disconnecting AC cord when
setting "Mode2" in power management, the TV may not
function properly after turning the power on again. In such
case, press TV POWER on the remote control unit.
• "Disable" is factory preset value.
@-33

Advertisement

Table of Contents
loading

Table of Contents