Setting The System - Sharp Aquos LC-45G1X Operation Manual

Preparation

Setting the System

After putting the Display and the AVC System in place, connect the system cables and AC cords. Use the
cable clamps for bundling the cables.
1
Removing the terminal cover
2
Connecting the system cable and the AC cord to the Display
3
Connecting the system cable and the AC cord to the AVC System
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
NOTE
* When you unplug the WHITE system cable, make sure you unscrew the screws thoroughly before unplugging the cable.
** When you unplug the GREY system cable, press the hooks on both sides of the cable inward as you unplug the cable gently.
LC-45G1X(E)-a
Display (rear view)
AC cord
• Plug in the AC cord
completely into the
terminal.
• Check the alignment of the
terminals before inserting.
AVC System (rear view)
7
Press the two hooks
toward the centre of the
Display and remove the
cover toward you.
Press down the four
upper hooks to remove
the cover toward you.
(BLACK)
System cable
System cable
(BLACK)
AC cord
04.10.15, 9:58 AM
(WHITE)*
Connect the plug into
the terminal and secure
it by tightening the
thumb screws.
(GREY)**
Connect the plug firmly
until the hooks on both
sides click.
(WHITE)*
(GREY)**
7