Declaration Of Conformity - Bosch GBL 800 E Professional Original Instructions Manual

OBJ_BUCH-759-003.book Page 8 Thursday, January 29, 2009 11:46 AM
8 | English
Noise/Vibration Information
Measured values determined according to
EN 60745.
Typically the A-weighted sound pressure level of
the product is 106 dB(A). Uncertainty K=1.5 dB.
The noise level when working can exceed
80 dB(A).
Wear hearing protection!
The hand-arm acceleration is typically below
2
2.5 m/s .
The vibration emission level given in this informa-
tion sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another. It
may be used for a preliminary assessment of ex-
posure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
ent accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly
increase the exposure level over the total work-
ing period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
1 609 929 R61 | (29.1.09)

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until 28 Dec 2009), 2006/42/EC
(from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 28.07.2008
Operation
Operating Modes
Before any work on the machine itself, pull
the mains plug.
Blowing (see figure A)
– For operation mode "blowing", firmly attach
the nozzle 7 in alignment with the arrow mark
onto the air outlet 5.
Vacuuming (see figure B)
– For operation mode "vacuuming", firmly at-
tach the nozzle 7 in alignment with the arrow
mark onto the air intake 9.
– Additionally, always mount the dust bag 8 on-
to the air outlet 5.
Bosch Power Tools