Miele KWT 6322 UG Operating And Installation Instructions page 45

Warnings in the display
Problem
The alarm symbol
; lis lit up and
both sensors for
the wine zones are
flashing in the
control panel. An
audible alarm is
also sounding.
The alarm symbol
; and the sensor
for one of the wine
zones is flashing
and an audible
alarm also sounds.
The Change active
charcoal filter
indicator — lights
up.
A dash is lit up
up/flashing in the
display.
"F1" to "F3" or "S1"
to "S9" appear.
Possible cause
The door alarm has been
triggered.
The temperature in the zone
concerned has risen higher
or fallen lower than the
temperature set. This could
be due to:
– the appliance door being
opened too often,
– a blocked ventilation
grille,
– a lengthy interruption of
the power supply.
This is a reminder to change
the filter.
Only temperatures within
the range the appliance can
display will be shown.
There is a fault.
Problem solving guide
Remedy
^ Close the door. Both
sensors and the alarm
symbol ; will go out and
the audible alarm stops.
^ Rectify the cause of the
alarm. The alarm symbol
; goes out and the
sensor for the zone
concerned lights up
constantly.
The audible alarm stops.
^ Replace the active
charcoal filter and then
confirm the filter change in
settings mode (see "Active
charcoal filter").
^ Call the Miele Service
Department.
45