Table of Contents
Advertisement
User Manual of DS-DVR04, DS-DVR08, DS-
DVR16 Series DVR
3.
Check the SNMP checkbox to enable this feature.
4.
Configure the SNMP settings.
5.
Click the Apply button to save and exit the interface.
Note:
Before setting the SNMP, please download the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the device is allowed to send the alarm event and
exception message to the surveillance center.
9.2.5 Configuring UPnP™
Purpose:
UPnP™ can permits the device seamlessly discover the presence of other network devices on the network and
establish functional network services for data sharing, communications, etc. If you want to use the UPnP™
function to enable the fast connection of the device to the WAN via a router, you should configure the
UPnP™ parameters of the device.
Before you start:
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of the router
to which your device is connected. When the network working mode of the device is set as multi-address, the
Default Route of the device should be in the same network segment as that of the LAN IP address of the
router.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the UPnP™ tab to enter the UPnP™ interface.
checkbox to enable UPnP™.
3. Check
4. Select the mapped type to Auto or Manual.
Figure 9.20 Configure SNMP Settings
Figure 9.21 UPnP™ Settings Interface
126
Advertisement
Table of Contents
