Ice - U-Line CLR1215 User Manual

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE

Ice

ICE CUBE THICKNESS ADJUSTMENT
Interval - As Required
NOTICE
Ice thickness adjustment should only be made
one increment at a time. Allow ice maker
production to stabilize for 24 hours before
rechecking ice thickness.
1. Press and release the LIGHT button key to exit the ice
thickness adjustment mode.
2. Remove all ice from the storage bin.
Ice cubes in any given batch will vary, so it is necessary
to choose cubes from the sample area for comparison
when making adjustments. If further adjustments are
desired, repeat Steps 1 through 4.
The ice cube thickness is factory set for best overall
performance. The factory setting is designed to maintain
an ice bridge of approximately 1/16" to 1/8" (1.6 mm to
3.2 mm) under normal conditions, resulting in a dimple of
approximately 1/4" to 1/2" (6.4 mm to 12.7 mm) in
depth. A fuller cube with less of a dimple results in a
thicker ice bridge. As the ice bridge becomes thicker, the
tendency for the cubes to stay together as a slab
increases. A bridge thicker than 1/8" (3.2 mm) may cause
cubes to overfill the ice bucket.
ICE BRIDGE
Ice Bridge and Dimples
(6.4 mm to 12.7 mm)
Ice thickness adjustments are made using the control
panel as follows:
1. To enter the thickness adjustment mode:
• Press and hold Up
• The display will switch to "0" to confirm the
thickness adjustment mode has been selected.
The factory setting is "0," and the total range of
adjustment is -5 to +5 (ideal range is -1 to +1). Use Up
to raise the setting and thicken the ice bridge, or Down
DIMPLES
to lower the setting to thin the ice bridge.
Cube Types
1/4" TO 1/2"
DIMPLE
THIN BRIDGE
LITTLE OR
DEEP DIMPLE
NO DIMPLE
for 5 seconds.
u-line.com
1/16" TO 1/8"
(1.6 mm to 3.2 mm)
ICE BRIDGE
THICK BRIDGE
Ice 1