Anti-Tip Bracket - U-Line CLR1215 User Manual

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE

Anti-Tip Bracket

1. Slide unit out so screws on top of unit are easily
accessible.
2. Remove the two screws from the opposite side of the
hinge assembly using a slotted screwdriver (see
below).
Note: 1224 models shown with four screw, 1215 models
only have three screws, but same screws are used in both
applications.
Right handed units shown, Left handed units are mirrored.
3. Place bracket (part #14154) over holes and attach to
unit with two screws removed in step 2 using a slotted
screwdriver. Tighten screws fully.
4. Gently push unit into position. Be careful not to
entangle the electrical cord, or water line if applicable.
5. Recheck the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" (3 mm) below
the counter top.
6. Secure bracket into adjoining surface.
u-line.com
Anti-Tip Bracket 1