U-Line CLR1215 User Manual page 24

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
4. Remove four screws from hinge holes on the opposite
side. Reinstall into holes where the hinge was
removed. Take care not to scratch cabinet.
Remove bottom hinge:
1. Remove bottom hinge from cabinet.
2. Remove corresponding screws on opposite side of
cabinet. On some models there may be a nut behind
one or both screws on either side.
Install bottom hinge:
1. Install two or three screws, depending on model.
Replace nuts if used.
Prepare door for reinstallation:
1. Rotate door 180° to reverse.
2. Remove gasket center strip and apply in-line with new
opening (approximately 2" lower).
Install top hinge and door:
1. Turn the plate over and reinstall the screws.
2. Hold door to keep it from falling.
3. Lift the door on to the bottom hinge.
4. Align flat edge of the hinge with the outer edge of the
unit.
5. Tighten three screws.
Align and adjust the door:
1. Align and adjust the door (see DOOR ALIGNMENT AND
ADJUSTMENT).
Install grille:
1. Install the grille.
u-line.com
Door Adjustments 2